RF energy is delivered from the output electrode to the ground plate by attaching the plate to skin surface, it is possible to deliver Thermal energy deeply.
Multipolar RF
Multiple RF poles on an electrode contact with skin and RF energy flows between opposite poles by a short route. Because of this, thermal energy is focused on the target layer.
Application of radio frequency technology
0.5 MHz
1 MHz
2 MHz
4 MHz
6.78 MHz
0.5 & 2 MHz RET(Resistive Electric Transfer)
The method generates deep heat due to electronic activity between the non-insulated electrode and the ground plate, and is mainly used in deep subcutaneous fat layers such as visceral fat and abdominal fat.
0.5 MHz CET - Maximum power is 300W
The machine uses an electrode that is contacted to skin has been covered with insulator and the ground plate uses a non-insulated metal plate to contact skin.
Active electronic activity occurs around the electrode in contact with the skin, making it effective in managing subcutaneous fat near the surface of skin tissue. It is also used to manage pain in joint areas where the muscles are not thick.
0.5 & 2 MHz Multipolar RF
Used on areas with many curves such as the face, neck, and décolleté. The energy reaches deep into the skin to burn lipocyte. The lower the frequency, the deeper the energy is transmitted, so use the appropriate frequency depending on the treatment area and purpose.
0.5 & 1 MHz Multipolar RF
Applying dual frequencies of 0.5 & 1 MHz creates a double heating zone in the target layer and delivers radiofrequency energy to a wider area, doubling the treatment effect.
4 MHz Thermal RF
Delivers 4 MHz Thermal RF to the dermis layer to regenerate collagen and elastin, making it effective in skin tightening and wrinkle improvement.
4 MHz Fractional RF
4 MHz Fractional RF creates an artificial scar on the dermis and remodels the elastin and collagen. So, it is usually used to improve pores and scars.
